The fitting can be removed and refitted for future access into the line.

Fitting DN70 - DN150 pipes of plastic, ductile, and cast iron materials, the AccessPoint is a perfect on-the-job essential.

Kits are provided with a diamond-tipped core drill, de-burring tool, and 6 mm Allen Key.
The core drill cuts a hole of 54 mm and is supplied with an arbour and a pilot drill.

Installation takes less than a minute, although this may increase when cutting into very old cast iron pipe.

Size Range: DN70 - DN150
Material: EPDM, GF Nylon, 1.4301 (304) Stainless Steel
Pressure Rating: 1 bar / 14.5 psi
Jetting Resistance: 180 bar
Temperature Range: -50°C to 80°C constant, 100°C intermittent
Tightening Torque: 6 Nm
Standards: BS EN 681-1:1996

The advantages of AccessPoint:

- Creates a professional and tidy finish

- Quick and easy installation

- Can be removed and refitted

- Pre-assembled for direct insertion into the host pipe